Description: Add a new area of Planting to the map.
Given I am on the map page with the plant layer active
When I select a plant to add to the map
When I click and drag an area on the map
Then I can see information about the sizes in a tooltip hovering next to the area of plantings
Then I can see that a new planting area has been added
When I select the new area of plantings
Then I can see in the plant attributes that there is an area of plantings
Then I can see that the values for Individual Plant Size, Plants per Row, Number of Rows, Total Plants, Length, and Width in "Area of Plantings" are equal to the information shown in the tooltip
Actual Result:
Test Result:
Notes:
Description: The tooltip showing the size of the planting area is clearly visible,
Description: Add a new area of Planting to the map.
Given I am on the map page with the plant layer active
When I select a plant to add to the map
When I click and drag an area on the map
Then I can see information about the sizes in a tooltip hovering next to the area of plantings
When I select a plant to add to the map
When I click and drag an area on the map, and at the same time I hover with the cursor over an existing plant or area of planting
Then I can see both the tooltip about the sizes and the label of the plant hovered over without overlap.
Actual Result:
Test Result:
Notes:
Description: Move a Planting area around the map.
Given I am on the map page with the plant layer active
When I drag a planting area
When I drop the planting area
Then I can see that the planting area was moved
When I select the Planting area
Then I can see in the plant area attributes that modified at and modified by are correctly set
Actual Result:
Test Result:
Notes:
Description: Edit an existing Planting Area on the map.
Given I am on the map page with the plant layer active
When I select a plant area that is already planted
When I select a corner/edge and drag it around
Then I can see information about the new sizes as a tooltip hovering next to the area of plantings
When I stop holding the mousebutton down
Then I can see that the planting area size has changed
Then I can see in the plant area attributes that modified at and modified by are correctly set
Actual Result:
Test Result:
Notes:
Description: Edit an existing Planting Area on the map.
Given I am on the map page with the plant layer active
When I select a plant area that is already planted
Then I can see detailed Information about this plant area in the left toolbox
When I edit the Length or Width
Then I can see that the planting area size has changed
Then I can see in the plant area attributes that modified at and modified by are correctly set
When I set the Length or Width to a non-positive value
Then I can see that the input is marked in red and the value was not applied
Actual Result:
Test Result:
Notes: